I don't want to strip the wall paper, I want to cut out the bad spot, bin the spot to seal it and the edges then mud over it and make it flush. Then I've got to do a patch on drywall covered by painted wallpaper. Someoneven said a skim coat of durabond will cover the water stains. Will bin work for this? I believe it will, but should I use the plaster weld instead? Or maybe a latex primer? Stud detector, strong magnet, bradawl etc. I was thinking of binning it then mudding over the edge to hide the line and blend it all together into a uniform surface. To successfully fix to a lath and plaster wall you will need the following tools and products: Timber batten of chosen width and length (3 x 2 or 4 x 2 and around 1.8 2.4m long) Handsaw or chop saw. I also want to seal the boarder where the still-tight wallpaper meats the exposed plaster with something. Now should I fill screw the holes with plaster weld before i install the screws? Can I get away with bin for this instead? Same goes with patching the large holes in the plaster: can I get away with binning the lathe and plaster edge my patch needs to grip to, or should I use plaster weld? Using the wrong paint to paint your walls, or using low-quality paint, could just cause your paint job to peel again in a few months or even weeks. So here'so what I want to do.ĭrill tiny holes in the rest of it up to the lath and force it back and anchor it with like 1.25 inch drywall screws. Smith says, Different surfaces do need different paints, so ensure you are purchasing the correct paint if you are painting wood, metal, or plaster. The rest of the area is pretty much sound as in the plaster hardly or doesn't move and the wall paper is tight with a couple sag or loose spots here and there. I peeled it back until it wouldn't come with my fingers anymore and reveiled the water stained, somewhat loose plaster which in some spots is very soft and practically falling off the wall. Long ago some water damage caused the paper to pull away. Remove any furniture near the area you are working on. It's a 45 degree wall that goes to the ceiling and its covered by painted wallpaper. Whenever we start a DIY project, even if its just a small repair, we start by protecting the surfaces in the room. I've got like a bump-out on anew upstairs landing that needs work.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |